Build Raspberry Pi circuits correctly, without guessing
Place components, connect GPIO pins, and catch conflicts in real time. Design your hardware setup before touching a single wire.
The part you need
is already here
Every component is modelled from its datasheet — pins, voltage levels, and protocols match the real hardware you'll buy.
- Specs sourced from real datasheets
- Sensors, actuators & modules ready to use
- Dependencies automatically resolved
- Customizable properties per component
Pins are
handled for you
Drag components onto a visual canvas and see your entire circuit instantly. Every GPIO pin is pre-mapped and labeled—no setup needed.
- Pre-configured Pi 4 & Pi 5 boards
- 40-pin GPIO table
- Pin roles and modes visible at a glance
Wiring without
the clutter
Every connection is clear and labeled, no reference sheets needed. As things grow, group or hide wires to keep your canvas clean.
- Automatic wire routing
- Connections update in real time
- Readable canvas no matter how complex the build gets
Validate Your Connections
in Real Time
Catch pin conflicts, missing connections, and wiring errors as you build. When the panel is clear, you’re ready to build.
- Instant pin conflict detection
- Missing connection alerts
- Clear, easy-to-understand warnings
From board selection to validated circuit in minutes
Start with Pi 4 or Pi 5, fully mapped and ready.
Drag sensors, actuators, and modules onto the canvas.
Draw wires between components and GPIO pins.
Add behavior to your components using logic blocks anytime.
Stop guessing your wiring
Design, validate, and build your Raspberry Pi circuits with confidence.